For Project Enquiry +91 9962 067 067

WORKING PRINCIPLE:

The compressed air from the compressor at the pressure of 5 to 7bar is passed through a pipe connected to the Solenoid valve with one input. The Solenoid Valve is actuated with Control Timing Unit. The Solenoid valve has two outputs and one input. The air entering into the input goes out through the two outputs when the timing control unit is actuated.  Due to the high air pressure at the bottom of the piston, the air pressure below the piston is more than the pressure above the piston. So these moves the piston rod upwards which move up the effort are, which is pivoted by control unit. This force acting is passed on to punch which also moves downwards.  The punch is guided by a punch guide who is fixed such that the punch is clearly guided to the die. The materials are in between the punch and die. So as the punch comes down the materials are sheared to the required profile of the punch and the blank is moved downwards through the die clearance.  When the piston is at the extreme point of the stock length, the exhaust valve is opened and the air is exhausted through it and the pressurized air come in at the top of the piston and it pushes the piston downwards. So the one side of the air is pulled downwards and the other side is lifted upwards. So the punch is therefore pulled upwards from the die. Now the piston reaches the bottom point of the required stroke length. Now the material is fed and the next stroke of the piston is made ready. When the material is correctly positioned then this machine is again actuated automatically. The time duration of the succeeding punching is adjusted with the help of control timing unit.